free hit
counters
Setting top-mounted clutch slave - Gearchange/Gearbox/Clutch - The Lotus Forums Jump to content
DaveyT

Setting top-mounted clutch slave

Recommended Posts

Note for setting top-mounted clutch slave and fork for clearance - the gospel according to Steve of SJ - not quite as per the manual.....

Set the pedal per the manual

for the slave, Do NOT remove the return spring before adjusting (the weight of the fluid just ends up forcing the pushrod out to take up any free space between it and the adjusting screw, my observation prompting a call to Steve)

bleed system fully , then wind the adjusting screw in towards the pushrod until, when you pull the top of the release fork back, there is no clearance.

now back it off until you have 1-2 mm clearance from the pushrod to the release fork when pulling the fork back to test it. You have a couple of seconds before the pushrod starts to activate.

job done.

Share this post


Link to post
Share on other sites

Upgrade today to remove Google ads and support TLF.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...