Reindeer 28 Posted September 28, 2020 Report Share Posted September 28, 2020 Hi All, The car is now regularly throwing a CEL for an o2 sensor.... Code P0154. Bank 2 Sensor 1. Looking back through the history its done this before so will change the sensor.... I've worked out its the pre cat sensor on Bank 2...... But....Which side of the engine is Bank 2?! Any help gratefully received! Quote Link to post Share on other sites
agentdr8 148 Posted September 28, 2020 Report Share Posted September 28, 2020 The side closer to the bulkhead/firewall. 1 Quote Link to post Share on other sites
21gg 401 Posted September 28, 2020 Report Share Posted September 28, 2020 Ive replaced mine a few weeks back. By a standard bosch sensor and a socket kit and it will be less than lotus price for the sensor. You will need to remove the heat shield, the rhs bolt/nut isn't captive so just be a little careful. You may need a bar to loosen the old one. Shouldnt take more than an hour. 1 Quote Link to post Share on other sites
Reindeer 28 Posted September 28, 2020 Author Report Share Posted September 28, 2020 Just my luck! Thank you Just now, 21gg said: Ive replaced mine a few weeks back. By a standard bosch sensor and a socket kit and it will be less than lotus price for the sensor. You will need to remove the heat shield, the rhs bolt/nut isn't captive so just be a little careful. You may need a bar to loosen the old one. Shouldnt take more than an hour. Did you do it from underneath or on top? Quote Link to post Share on other sites
21gg 401 Posted September 28, 2020 Report Share Posted September 28, 2020 On top, just kneel in the boot. You dont want the socket that looks like a normal socket but the one that looks like a figure 8, where your bar goes next to the socket. Its obvious what i mean if you look on ebay. Quote Link to post Share on other sites
Reindeer 28 Posted September 28, 2020 Author Report Share Posted September 28, 2020 Sorry and did you buy one of those 22mm special o2 sensor sockets? Just now, 21gg said: On top, just kneel in the boot. You dont want the socket that looks like a normal socket but the one that looks like a figure 8, where your bar goes next to the socket. Its obvious what i mean if you look on ebay. Yeah I've seen two types....that one and a normal one with a cut out.....I was hoping to get a normal spanner in there Quote Link to post Share on other sites
21gg 401 Posted September 28, 2020 Report Share Posted September 28, 2020 Yes one like this 1 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.