PaulM 33 Posted February 12 Author Report Share Posted February 12 On 11/02/2021 at 02:03, Lex Templar said: These look great @PaulM what is the difference between machining and diamond cut? Both obviously involve taking material off the surface on a lathe. Any pics of the fronts? Lex. Machining is flat and doesn’t leave a pattern, diamond cut leaves ridges and creates a circular ‘pattern’. Quote Link to post Share on other sites
PaulM 33 Posted February 12 Author Report Share Posted February 12 21 minutes ago, RichardJGC said: At last....a company that knows what they are doing with CX500’s. I knew if I held out long enough the right people would appear. Wheels look stunning! Absolutely - I must’ve contacted twenty companies, most had stopped doing 3pc wheels, the few that did still offer it sounded like they didn’t understand what these wheels specifically needed. Voodoo hadn’t done these wheels before but clearly knew their stuff on 3pcs and were willing to listen to what I wanted/find ways around problems etc. Great guys, definitely a good find. 2 Quote Link to post Share on other sites
RichardJGC 381 Posted February 12 Report Share Posted February 12 It was the diamond cutting i didn't like which most companies employed. Looked too much like a record close up, so its great that these people took the time to find a better way. They will definitely be getting a visit in due course! Thank you for posting the results. 1 Quote Link to post Share on other sites
Popular Post PaulM 33 Posted February 21 Author Popular Post Report Share Posted February 21 Okay - so wheels and tyres done! Full write up under the wheels tyres forum but a few pics here, delighted with the result. 3 2 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.