JR Posted September 8, 2021 Report Share Posted September 8, 2021 September's stupid question. My 1988 X180 N/A's gearstick knob is getting loose. It rotates a little bit and also moves up and down. On gear changes I have to push it down (a bit) to keep it from moving (apart from the required gear change travel). Any tips? Quote Link to comment Share on other sites More sharing options...
DaKa Posted September 11, 2021 Report Share Posted September 11, 2021 I had the same problem, not sure though if mine had been glued into place by the previous owner of they are normally just a pushon fit? I pulled the knob off my stick carefully and completely (hard to say that without smiling) and then rapped a strip of silicone tape tightly around the top end of the stick. It make the size wider meaning that when I pushed the knob back on it was much tighter fit and has stayed solid for more than3 years now. I did look into replacements, but not sure it's an easy swap o/a the reverse lift? 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.