RH rear upright VSS sensor connector clearance

[mike_sekinger]

I`m looking for a favour from the 4-cylinder crew.

Does anyone have an image of the RH rear upright VSS connector installed?   I`m looking to establish the clearance from the ribs either side

This is for the CNC rear upright project, where we have thicker ribs and just want to check clearance.

[tomcattom]

That what you're after @mike_sekinger.?

[fjmuurling]

Looks like my vss is different.
 

At the moment I’m away so maybe Sunday evening late or Monday.

[mike_sekinger]

Thanks @tomcattom  Exactly what I was looking for.

@fjmuurling  If you could also give some dimensions to the loom side connector, the would help.

[fjmuurling]

@mike_sekinger as promised, took the wheel off, hope you have enough info with the below pictures. As you can see there is a difference in the sensor, my sensor connector is centered whereas "Tom's" sensor seems to be offset.

 

Looks like my sensor is centered in the teardrop footprint. The outside of the connector securing clip (yelow line) is in line with the inside of the web.

 

The bottom of the securing clip sits 15 mm above the machined Hub Carrier VSS flat.

 

 

[mike_sekinger]

@fjmuurling Thank you Freek.  That helps.