free hit
counters
engine torque - Engine/Ancilliaries - The Lotus Forums Jump to content
Sign in to follow this  
Brabbs

engine torque

Recommended Posts

Hi

just in the process of rebuilding my 2.2 turbo 1989 (carb) esprit. what I am unable to find is the head torque, big end torque and valve clearance

can any one be so kind to throw some light on this and advise me

kind regards

Share this post


Link to post
Share on other sites
Upgrade today to remove Google ads and support TLF.

Hi Brabbs,

According to the service notes for the S4 & S4s,

Big end bearings, 104 - 107 nm

Inlet valve clearance 0.13mm to 0.18mm

Exhaust valve clearance 0.25mm to 0.31mm

hope this helps.

cheers

Dave

Share this post


Link to post
Share on other sites

According the the workshop manual for turbo and SE, torque for the head bolts is as follows:

Each end pair: 95 Nm

3 middle pairs 100 Nm

Tightening sequence is clockwise working from the center pair towards the outside.

8---6--1--3--9

10--4--2--5--7

Share this post


Link to post
Share on other sites

Hi again,

forgot about the head bolts,

again from the service notes of the S4, S4s and sport 300,

Tighten nuts progressively in a diagonal sequence working outwards from the centre, in five stages.

i) 20Nm,

ii) + 75 angular degrees,

ii) + 40 angular degrees,

iv) wait 5 minutes,

v) + 20 angular degrees

Tightening sequence

8 6 1 3 9

x x x x x

Front-->

x x x x x

10 4 2 5 7

x's represent the head nuts.

cheers

Dave

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...