Front Bumper/Oil Cooler covers

[Ginger pig]

All,

 

I have replaced my 89SE body shell with an 89 carb turbo body shell due to fire damage. I have had to make several corrections (i.e. drill additional holes). I have come to fit the oil cooler covers (one each side) and realised that I have not the foggiest as to where they fit exactly on the body. When I have offered them up to the radiator cover, they over hang the perimeter of the body by 1cm each side. I could pontentially attach them to the fibre glass brackets/mounts that are riveted to the body. Has any one got any photos of an SE without the front bumper attached so that I can see the sequence of fitting and also the position of the oil cooler covers? It would be much appreciated if you could see your way through to posting some.

 

Mark

[Vulcan Grey]

I have my front lower valence removed, bumper is still on, the radiator pack is in, but not the oil coolers yet.

 

I could take pics of where the oil cooler ducts attach, but I don't think they'll fit within the valence of an 89 non-SE...

[Ginger pig]

Thanks Travis,

 

Only the body is non SE so all the bumpers etc are SE.

 

Any photos might prove very helpful!

 

I have the oil coolers in with all the pipe work and although the car is pretty much a mixture of 3 cars; the car is all SE components bar the actual body (which should be generic to SE and non SE). I cannot work out where the oil cooler outer sides should sit as they seem to overlap the body by about a cm.

 

Mark

[Vulcan Grey]

Ok, I'll take some pics while I am under there this weekend.

 

I'm also replacing all my suspension bushings now.

[Ginger pig]

Thanks Travis,

 

You are a star!