free hit
counters
Fuel Rail seals - Engine/Ancilliaries - The Lotus Forums - Official Lotus Community Partner Jump to content


IGNORED

Fuel Rail seals


alzmoore

Recommended Posts

It very nearly started, but then started dripping fuel from the first connector to the mail fuel rail.  I can't see how the end of the fuel rail comes of. It has a 22mm thin hexagon  with a treaded boss to take the fuel pipe connector from the inlet plenum. Does anyone have any tips about how to take it out to replace the seals with damaging it?  I can't see what holds it in place,  the PRV at the other end of the rail has a locking plaate but this seems to be just pushed in...it's tight and won't pull out, but leaks lots...

 

Thanks

 

Alan

Link to comment
Share on other sites


Upgrade today to remove Google ads and support TLF.
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

It is a press in fitting.

 

Most people recommend not trying to remove it unless it has failed, since it won't go back in correctly, and is not easily replaced...  

 

You could weld an AN fitting on the end and use standard AN fittings for the fuel system.

 

http://www.thelotusforums.com/forums/topic/9798-fuel-lines-upgrade/

Travis

Vulcan Grey 89SE

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



Upgrade today to remove Google ads and support TLF.


×
×
  • Create New...