Front undertray

[andy b]

I had a pair of originals with the turbo. I have never had any on the NA HC so i decided to see if i could mould some off the originals this is the result a little bit of trimming and will fit fine.

[andy b]

This we/end's work put some paint on the under tray's  i have not got to fussy they are going to get scraped as the originals.

 

Also milled out of solid ali the numberplate plinth for the NA HC.

then fixed some new heat shield stuff on the turbo engine cover the original mesh was rusty and holed so i made a new one from s/steel mesh.

All these jobs take ages i have just found the brackets that fix to the bulk head for the gas struts so now i have to remove the seats and back panel to refit them. again thanks to the forum and bibs for the parts manual i would not have a clue what they were for or where they went a lot of this ebay purchase was in boxes. Still better than something flat packed from ikea