Jphoenix13 Posted January 23, 2017 Report Share Posted January 23, 2017 My 95 S4 clutch pedal is getting a bit long and I suspect it's getting close to the wear limit at 51,000 miles. Any suggestions for a clutch kit (pressure plate, disc and TO bearing) for this year S4? Intereste in cost, including U.K. sources as I've found parts for my TR6 are less expensive and better quality from the UK these days, even with shipping. Any suggestions greatly appreciated. Anything else I should do while I'm in there? Jim Quote Link to comment Share on other sites More sharing options...
jonwat Posted January 23, 2017 Report Share Posted January 23, 2017 SJSportscars should have everything you need & PUK Esprit also do clutch kits as do PNM. Quote Cheers, John W http://jonwatkins.co.uk Link to comment Share on other sites More sharing options...
Jphoenix13 Posted January 23, 2017 Author Report Share Posted January 23, 2017 Thanks John, that's what I needed. Quote Link to comment Share on other sites More sharing options...
Vulcan Grey Posted January 23, 2017 Report Share Posted January 23, 2017 JAE in California http://www.jaeparts.com/contact/ I replaced the rear main seal and pilot bearing while in there. I also had my flywheel Blanchard Ground, but don't do that unless absolutely needed... Quote Travis Vulcan Grey 89SE Link to comment Share on other sites More sharing options...
Jphoenix13 Posted January 24, 2017 Author Report Share Posted January 24, 2017 What did the clutch kit cost Travis? I buy most of my parts from JAE, but they don't have prices on their website. Doing the rear main and pilot bush good idea. I expect I'll need to pull the engine out to do it, so likely go after cam followers, seals etc. tempting just to do the whole thing and have the head freshened as well, but I know the machine shop will talk me into the larger S4S valves, etc. Quote Link to comment Share on other sites More sharing options...
Vulcan Grey Posted January 24, 2017 Report Share Posted January 24, 2017 I think it cost about $500 ish back in 2002... Quote Travis Vulcan Grey 89SE Link to comment Share on other sites More sharing options...
Zig Posted February 8, 2017 Report Share Posted February 8, 2017 (edited) You can always have clutch disk rebuilt or modified using 16 pucks... (see picture) and just buy pressure plate and clutch bearing. Zig Edited February 8, 2017 by Zig Quote Link to comment Share on other sites More sharing options...
jfitz981 Posted February 21, 2017 Report Share Posted February 21, 2017 Hey Zig, Any recommendation for a company that does the refurb/upgrade to the worn clutch? Thanks. Quote Link to comment Share on other sites More sharing options...
Zig Posted March 11, 2017 Report Share Posted March 11, 2017 (edited) I used Buffalo Clutch Co. as recommended Keny (89esprit ) in previous post (attached below). Craig from Buffalo Clutch said that my pressure plate fingers were too worn out to rebuild, but they did use my clutch disk to rebuild it as 16 puck disk. Contact: Craig Buffalo Clutch Co 1810 Dale Road Cheektowaga, NY 14225 Phone: 716-892-2828 Fax 716-892-2727 Edited March 11, 2017 by Zig Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.