free hit
counters
O2 sensor problem probably.....SJ part ok? - Engine/Ancilliaries - The Lotus Forums Jump to content
Sign in to follow this  
pureguava

O2 sensor problem probably.....SJ part ok?

Recommended Posts

 Hi

i suspect I have an O2 sensor issue and want to make sure the one I have ordered from SJ is ok?

I recently removed my cat and installed an alunox 3inch dual exit exhaust ( very very nice and easy install) and the stainless manifold. 

I couldn’t no matter how I tried could get out my old O2 sensor so bought the Bosch sensor equivalent...13030? 

If I idle for longer than 1 minute it suddenly increases revs by about 500 and the CEL comes on .   If the sensor is disconnected it does not happen  

Free scan shows a O2 sensor voltage of about 0.4 with engine off and a rock steady 0.004(!!!) with engine running - no fluctuations at all I suspect this sensor is not usable....I have ordered a new one from SJ is this one known to be OK?

 

 

Share this post


Link to post
Share on other sites

Upgrade today to remove Google ads and support TLF.

That sensor voltage should fluctuate all over the place.


Only here once

Share this post


Link to post
Share on other sites

Yes!! Problem solved......one of the sensor wires was sketchy.  I found when I was unscrewing the sensor it started fluctuating in freescan.   Traced it back to one dodgy wire!!

all solved ....thanks again!!

al

  • Like 2

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...